'Squiggles' Drip Glass Platter

Figure A

Steps:

1. Fill a flowerpot with glass scrap, and then elevate it above a clean, kiln-washed kiln shelf using kiln furniture (figure A). Heat the flowerpot to 1700-degrees, allowing the glass to form a very liquid (drip) state so it will flow through the hole in the bottom of the flowerpot creating a puddle of glass.

Figure B

2. Once the glass has cooled completely, remove the glass puddle (drip) from the flowerpot. It will be in the shape of a pancake (figure B). Cut it into thin strips with a tile cutter at the tile saw.

Figure D

3. Bend the cut strips into "squiggles" with the heat of the torch to maneuver the glass. Hold the glass at the outer most tip of the flame, to avoid thermal shock, and slowly, as it heats, bring it further into the flame, and then gently press it into the desired squiggle shapes (figure D).

Figure F

4. Cut a glass sheet into two rectangular pieces and stack to form two layers. Also cut black strips to fit around the edge of the rectangles for the platter’s border (figure F).

Figure G

5. Dam the project with pieces of heavy brick all around the edges to ensure a good tight connection of the black edge trim and the larger rectangles during the firing. Also, to ensure a release from the bricks, place 3/8-inch strips of fiber paper around all four sides of the rectangle. Decorate the tray with the squiggles (figure G) and other pieces of glass. Place the drip glass platter into the kiln and fire. The firing schedule will take a full day to heat and cool.

Figure J

6. Remove from the kiln and start cold working the edges with a belt sander.

• First sanding with 60-grit, then 80-grit, then 120-grit, then 220-grit, and finally 400-grit for the fine finish needed on the edges before putting it back into the kiln.
• Fire in the kiln for slumping which is what gives the platter its shape.
• Firing will take a full day to heat and cool.

7. Shape feet for the bottom of the platter into marbles with a special marver just for this purpose (figure J). Remove them from the punty and place them into a small annealing kiln.

Figure K

8. Grind the marble feet on one side and attach with UV glue to the bottom of the glass platter (figure K).

9. Level the feet (marbles) at the disc sander to ensure that the platter is balanced and doesn't wobble.